ENDCAP DISPLAY REQUIREMENTS & FORM
Exhibitors with 10x20 Booths facing THREE aisles are REQUIRED to complete this form. 
Form due by ASAP.

To ensure that all Endcap Exhibitors understand the requirements and comply with the policy at show site, a name and date is required. Please take a few minutes to read over this page.

If you prefer to complete a PDF version of this form and submit via fax ~ CLICK HERE. 
Otherwise continue below to submit data to Show Management via email.

---

Exhibitors displaying in End Cap booths have certain set-up requirements that must be met in order to maintain the line of sight down the aisle. Following (for your convenience) is a description and requirement of an End Cap booth space:

End Cap Booth Description
Back-to-back corner exhibit spaces combined to make one booth facing an aisle.

Mandatory Requirements
End cap booths have a back wall 20’ wide. The center 10’ of that back wall may contain a display 8’ high. The 5’ high on either side of that center portion are limited to displays 4’ in height. Exhibitors in end cap booths must finish the back portion of their space so it will not be objectionable to the adjacent exhibitors. The Texas Food & Fuel Expo reserves the right to have such finishing done and bill the exhibitor for charges incurred.

To see the diagram of an End Cap Booth ~ CLICK HERE.

As you can see from the diagram link above, the end cap booth space has some advantages, and potential disadvantages, depending on the nature of your display.

An End Cap booth is not designed for firms that have professionally constructed or pre-fabricated exhibit displays more than 10 feet wide or eight feet tall. Another area in the show, such as a standard in-line booth would be more appropriate for booths of this design.

The primary concern in setting up an end cap booth is maintaining the line of sight down the aisle.  This ensures each exhibitor has potential visibility from the cross aisles in the show.

Please contact Dana Fuller with TGCA, Show Management at 800/856-8342, dana@txgca.org, if you have any questions or concerns regarding an End Cap Booth. 

Form:
 Yes, our company understands the end-cap rule and will comply with the policy on show site.

       Exhibiting Company:
       Booth Number:
       Phone Number: (000-000-0000)
       Submitted By:              

---